Previous
Next
€565.00 * €595.25 * (5.08% Saved)
Prices incl. VAT plus shipping costs*
Special Order: Estimated Shipping in 4 workdays*,
(if available at manufacture*)
- Order number: EDL-2042
- Notes:
The set consists of
1x | RPM Air Gap Manifold, Chevrolet Small Block,... | €469.75 |
1x | Intake Gasket, Chevrolet 302-327-350-400, '58-'86 | €32.00 |
1x | Plated Intake Bolt Kit, Chevrolet Small Block... | €40.25 |
1x | Carburetor Stud Kit, 1.375 Inch, Zinc | €17.75 |
1x | Base Gaskets, For Edelbrock/Square-Bore, Set of 2 | €20.25 |
1x | Silincone Gaskets, RTV, 15ml, Black | €15.25 |
Total: | €595.25 |
Compared to the single purchase
€30.25
saved!
Edelbrock Part # 2042 Manifold Installation kit will simplify the process of adding more power... more
Edelbrock 2042 - RPM Air Gap Manifold Kit, Chevrolet Small Block, 55-86
Edelbrock Part # 2042 Manifold Installation kit will simplify the process of adding more power and efficiency to your street rod or muscle car. It combines all the necessary components to replace your stock iron intake manifold with an Edelbrock aluminum intake manifold. Kit includes: Performer RPM Air Gap intake manifold #7501, intake gasket set, carburetor base gasket, RTV sealant, intake bolts and carb studs.
- Clean positive seal
- Embossed silicone bead surrounding the port
- Matched to manifolds and cylinder heads
Color/Finish: | Satin |
Carburator Setup: | Single-Carburator |
Car/Engine: | Chevrolet Small Block |
Engine Notes: | 262-400 cui - 1986 and earlier |
Serie: | RPM Air-Gap |
Related links
Installation Notes
-
- Manifold height: A-4.20", B-5.25" (.70" taller than #2101)
- Carburetor pad height: 4.27"
- Port exit dimensions: 1.14" x 1.95"
- Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.
- Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
- NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure a proper seal.
- DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
- Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
- Will not fit under stock Corvette hood.
- Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Variants available
Variants available
Variants available
Variants available
Viewed