Prices incl. VAT plus shipping costs*
In Stock - Ready to ship,
Delivery time appr. 1-3 Workdays
- Order number: EDL-7116
- Notes:
Edelbrock Part # 7116 Performer RPM Vortec intake manifold is Based on the powerful Edelbrock #7101, this single four-barrel intake is designed for the street rod, marine and engine swap market utilizing 262-400 c.i.d. Chevy V8's with 1996 and later Vortec (L31) cast iron or Edelbrock E-Tec aluminum heads. An external water bypass boss is machined into the front of the water crossover for use on 1996 and later Vortec production engines. Manifold accepts square-bore carbs only. For street and marine engines operating from 1500-6500 RPM, see the Performer Vortec manifold or Performer Vortec EPS. Will not fit under stock Corvette hood.
- Best for the ultimate in street high-performance
- Designed for 1500 to 6500 RPM street-driven power
- Produces Incredible top-end horsepower
- Retains good throttle response and acceleration
- Larger plenum and runners maximize other upgrades
- For 1996+ GM Vortec or Edelbrock E-tech heads
- Accepts square-bore carburetors only
- Engine Swaps
Car/Engine: | Chevrolet Small Block |
Engine Notes: | 262-400 cui Vortec - 1996 and later |
Color/Finish: | Black, Satin |
RPM Range: | 1500-6500 |
Serie: | Performer RPM |
Emission: | Without EGR |
Flange: | Square Bore |
Intake Style: | Dual Plane |
Usage: | Street |
Carburator Setup: | Single-Carburator |
-
- Manifold height: A-4.20", B-5.25" (.70" taller than # 2101)
- Carburetor pad height: 4.27"
- Carburetor recommendations: Edelbrock AVS2 or Performer Series 650-800 cfm. Use bracket # 8032 for 1972-78.
- Camshaft Recommendations: Performer RPM #7102, #2201 and #2204
- Port exit dimensions: 2.05" tall with slanted sidewalls
- Recommended intake gasket: Edelbrock # 7235 or GM # 89017465
- Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.
- Use # 8516 Edelbrock bolt kit
- Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
- NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure a proper seal.
- DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
- Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
- Will not fit under stock Corvette hood.
- Stock brackets will require modification to fit the upright manifold bolt holes. Use Edelbrock Vortec throttle bracket # 8032.
- Edelbrock does not recommend the use of an economy type carburetor such as the Performer series # 1406 or # 1411 on Performer RPM Intake Manifolds. Economy type carburetors are calibrated lean for fuel economy and will not perform properly on this style of intake.
- Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.
Variants available
Variants available
Variants available