RPM Air Gap Manifold Kit, Chevrolet Small Block, 55-86

565,00 € 595,25 € (5,08% gespart)

inkl. MwSt. zzgl. Versandkosten

Sonderbestellung: Geschätzter Versand in 4 Arbeitstage*,
(falls beim Hersteller verfügbar*)

Artikel-Nr.: EDL-2042
Notes:

RPM Air Gap Manifold, Chevrolet Small Block,...

Intake Gasket, Chevrolet 302-327-350-400, '58-'86

Plated Intake Bolt Kit, Chevrolet Small Block...

Carburetor Stud Kit, 1.375 Inch, Zinc

Base Gaskets, For Edelbrock/Square-Bore, Set of 2

Silincone Gaskets, RTV, 15ml, Black

1x	RPM Air Gap Manifold, Chevrolet Small Block,...	469,75 €
1x	Intake Gasket, Chevrolet 302-327-350-400, '58-'86	32,00 €
1x	Plated Intake Bolt Kit, Chevrolet Small Block...	40,25 €
1x	Carburetor Stud Kit, 1.375 Inch, Zinc	17,75 €
1x	Base Gaskets, For Edelbrock/Square-Bore, Set of 2	20,25 €
1x	Silincone Gaskets, RTV, 15ml, Black	15,25 €

Summe: 595,25 €

Gegenüber dem Einzelkauf

30,25 €

gespart!

Edelbrock Part # 2042 Manifold Installation kit will simplify the process of adding more power... mehr

Menü schließen

Edelbrock 2042 - RPM Air Gap Manifold Kit, Chevrolet Small Block, 55-86

Edelbrock Part # 2042 Manifold Installation kit will simplify the process of adding more power and efficiency to your street rod or muscle car. It combines all the necessary components to replace your stock iron intake manifold with an Edelbrock aluminum intake manifold. Kit includes: Performer RPM Air Gap intake manifold #7501, intake gasket set, carburetor base gasket, RTV sealant, intake bolts and carb studs.

Clean positive seal
Embossed silicone bead surrounding the port
Matched to manifolds and cylinder heads

Color/Finish:	Satin
Carburator Setup:	Single-Carburator
Car/Engine:	Chevrolet Small Block
Engine Notes:	262-400 cui - 1986 and earlier
Serie:	RPM Air-Gap

Weiterführende Links

Menü schließen

Installation Notes

- Manifold height: A-4.20", B-5.25" (.70" taller than #2101)
- Carburetor pad height: 4.27"
- Port exit dimensions: 1.14" x 1.95"
- Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.
- Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
- NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure a proper seal.
- DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
- Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
- Will not fit under stock Corvette hood.
- Proper installation is the responsibility of the installer. Improper installation will void your warranty and may result in poor performance and engine or vehicle damage.