Performer Plus Cam & Lifters Kit, AMC 290-401

Performer Plus Cam & Lifters Kit, AMC 290-401

455,25 €

inkl. MwSt. zzgl. Versandkosten

In Stock - Ready to ship,
Delivery time appr. 1-3 Workdays

Artikel-Nr.: EDL-2132
Notes: Produces 275 ft.-lbs. when matched with #2131 intake and stock heads

Designed for optimum torque from the low-end to the mid-range, Performer-Plus camshafts match... mehr

Menü schließen

Edelbrock 2132 - Performer Plus Cam & Lifters Kit, AMC 290-401

Designed for optimum torque from the low-end to the mid-range, Performer-Plus camshafts match with Performer manifolds for vehicles operating from off-idle to 5500 rpm. They are smooth idling cams for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. In the manifold section you'll find torque graphs showing the power gains from Performer manifolds and Performer-Plus cams. All camshafts include flat tappet lifters (except for cams designed for use with stock roller lifters), assembly lube and instructions. These popular Performer-Plus camshafts for Small-Block Chevy are 50-state street legal.

Designed for optimum torque and acceleration
Maximum performance from idle through mid-range
Matched to Edelbrock Performer intakes
Includes hydraulic lifters and assembly lube
Major improvement in throttle response and torque
Use for daily drivers/trucks/vans/RVs/4x4s
Take the guesswork out of camshaft selection

Car/Engine:	AMC / Jeep
Engine Notes:	290-304-343-360-390-401 cui
Camshaft Type:	Hydraulic Flat Tappet
Serie:	Performer-Plus
RPM Range:	Idle-5500
Duration @ .050 Int/Exh:	204°/214°
Lift @ Valve Int/Exh:	.448"/.472"
Lobe Separation:	110°
Intake Center Line:	105°
Idle Vacuum @ 1000 RPM:	15"

Weiterführende Links

Dokumentation... mehr

Menü schließen

Verfügbare Downloads:

Download Instructions

Menü schließen

Installation Notes

- Recommended Valve Springs for OEM heads: Edelbrock part # 5832 non-rotator/# 5932 Rotator
- In order for this Performer-Plus cam and lifter kit to be covered under ANY WARRANTY you must use either the correct Edelbrock Sure Seat valve springs or the stock original equipment valve springs.
- Oil/additive must contain Zinc designed for use with flat tappet camshafts.
- Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.
- Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.