Performer Plus Cam & Lifters Kit, Chevrolet Small Block, E-Street, EFI

Performer Plus Cam & Lifters Kit, Chevrolet Small Block, E-Street, EFI

€ 377,50 *

Prijzen incl. btw excl. verzendingskosten

In Stock - Ready to ship,
Delivery time appr. 1-3 Workdays

Productnr.: EDL-2117
Notes: Produces 338 hp and 389 ft-lbs. of torque when matched with a Performer EPS intake manifold #2701, E-Street cylinder heads #5089 and EFI system.

Designed for optimum torque from the low-end to the mid-range, Performer-Plus camshafts match... meer

Menu sluiten

Edelbrock 2117 - Performer Plus Cam & Lifters Kit, Chevrolet Small Block, E-Street, EFI

Designed for optimum torque from the low-end to the mid-range, Performer-Plus camshafts match with Performer manifolds for vehicles operating from off-idle to 5500 rpm. They are smooth idling cams for daily drivers, trucks, vans, RVs and 4x4s. You can expect a major improvement in throttle response and torque. In the manifold section you'll find torque graphs showing the power gains from Performer manifolds and Performer-Plus cams. All camshafts include flat tappet lifters (except for cams designed for use with stock roller lifters), assembly lube and instructions. These popular Performer-Plus camshafts for Small-Block Chevy are 50-state street legal.

Designed for optimum torque and acceleration
Maximum performance from idle through mid-range
Matched to Edelbrock Performer intakes
Includes hydraulic lifters and assembly lube
Major improvement in throttle response and torque
Use for daily drivers/trucks/vans/RVs/4x4s
Take the guesswork out of camshaft selection

Car/Engine:	Chevrolet Small Block
Engine Notes:	283-400 cui V8 1957-1986
Camshaft Type:	Hydraulic Flat Tappet
Serie:	Performer-Plus
RPM Range:	Idle-5500
Duration @ .050 Int/Exh:	218°/224°
Lift @ Valve Int/Exh:	.464"/.470"
Lobe Separation:	114°
Intake Center Line:	110°
Idle Vacuum @ 1000 RPM:	15"

Verdere links

Documentatie... meer

Menu sluiten

Beschikbare downloads:

Download Instructions

Menu sluiten

Installation Notes

- Recommended Valve Springs for OEM heads: Edelbrock part # 5703 non-rotator
- In order for this Performer-Plus cam and lifter kit to be covered under ANY WARRANTY you must use either the correct Edelbrock Sure Seat valve springs or the stock original equipment valve springs.
- Oil/additive must contain Zinc designed for use with flat tappet camshafts.
- Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.
- Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.