Performer RPM Camshaft Kit, Ford 289-302

Performer RPM Camshaft Kit, Ford 289-302

€ 537,50 *

Prijzen incl. btw excl. verzendingskosten

In Stock - Ready to ship,
Delivery time appr. 1-3 Workdays

Productnr.: EDL-7122
Notes: 367 HP & 340 ft.-lbs. with #7121 intake & #60259 heads. Not for 1985-later engines with roller lifters. Screw-in studs, guide plates and adjustable rocker arms required.

Designed for street high-performance applications, Performer RPM cams provide power from 1500 to... meer

Menu sluiten

Edelbrock 7122 - Performer RPM Camshaft Kit, Ford 289-302

Designed for street high-performance applications, Performer RPM cams provide power from 1500 to 6500 rpm. These hydraulic lifter camshafts are dyno-matched to Performer RPM manifolds for high-rpm horsepower while still maintaining acceptable low-end torque. With 10 to 12 inches of manifold vacuum at idle, Performer RPM cams have more lift and duration than most street camshafts. In the manifold section, you'll find horsepower graphs showing the power levels obtainable when the Performer RPM package is used with the right combination of Edelbrock components. Hydraulic flat tappet lifters are included with each Performer RPM camshaft.

Designed for 1500 to 6500 performance
Maximum power in high-RPM with good low-end torque
Matched to Edelbrock Performer RPM intakes
10 to 12 in. of manifold vacuum at idle
More lift and duration than most street camshafts
Includes hydraulic lifters and assembly lube
Dyno matched/street proven performance
Take the guesswork out of camshaft selection

Car/Engine:	Ford 260-289-302
Engine Notes:	289-302 cui
Camshaft Type:	Hydraulic Flat Tappet
Serie:	Performer RPM
RPM Range:	1500-6500
Duration @ .050 Int/Exh:	224°/234°
Lift @ Valve Int/Exh:	.496"/.520"
Lobe Separation:	112°
Intake Center Line:	107°
Idle Vacuum @ 1000 RPM:	11"

Verdere links

Documentatie... meer

Menu sluiten

Beschikbare downloads:

Download Instructions

Menu sluiten

Installation Notes

- Recommended Valve Springs for OEM heads: Edelbrock part # 5722
- Not for 1985-later engines with roller lifters.
- Screw-in studs, guide plates and adjustable rocker arms required.
- For non-computer controlled vehicles
- Use only stock ratio rocker arms
- Adjustable valvetrain required
- In order for this Performer RPM cam and lifter kit to be covered under ANY WARRANTY you MUST use the correct Edelbrock Sure Seat Valve Springs or equivalent.
- Do not use rotator type valve springs or retainers for this application.
- Oil/additive must contain Zinc designed for use with flat tappet camshafts.
- Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.
- Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.

Lees, schrijf en bespreek beoordelingen...meer

Menu sluiten

Klantbeoordelingen voor "Performer RPM Camshaft Kit, Ford 289-302"

Beoordeling schrijven

Beoordelingen worden na controle vrijgegeven.